Installing left and right tie rod ends
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing tie rod end
- Screw the tie rod end onto the tie rod up to the dimension (A), which was determined before removal.
If necessary, hold the track rod with an open-end spanner for counter support.
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Tie rod end to tie rod M10 Tightening torque 32 Nm - Position the tie rod end (2) on the swivel bearing (3).
- Replace nut (1).
Parts: Nut
- Tighten nut (1). If necessary, counter support at the Torx socket.TIGHTENING TORQUE SPECIFICATION
Tie rod end to swivel bearing M14 Replace nut. Tightening torque 165 Nm