Install the left-hand and right-hand crash lever

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

NOTE: Perform the steps on the right and left side.

Version A:

Position the crash lever (3) on the front subframe.

Tighten screws (1) and (2).

TIGHTENING TORQUE SPECIFICATION

Crash lever on frame/adapter of front subframe
M14	Tightening torque 100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Version B:
Replace the cage nut (1).

Parts: Cage nut

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
Position the tension strut and crash lever (2) on the front subframe.
Replace the screw (1).
Parts: Screw
Feed in screw (1) and tighten hand-tight.
The screw connection is tightened later in NORMAL POSITION .
On version B: Install the front underbody protection (1) and the lower wheel arch covers (2) only after tightening the threaded connection of the tension strut at the front subframe.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
For additional information see: Tighten the screw connection of the tension strut on the left and right.
Tighten the screw (1) of the tension strut (2) on the front subframe in NORMAL POSITION only following the follow-up work .

Courtesy of BMW OF NORTH AMERICA, INC.