Fasten the wishbone on the front axle support

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2022 BMW M340i xDrive, 2022 BMW M340i, 2022 BMW 330i xDrive, 2022 BMW 330i, and 2022 BMW 330e xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Release the screw (1). In doing so, counter support at the nut (2).
Replace screw (1) and nut (2).
Parts: Screw, nut
Insert screw (1) and guide on the nut (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The screw connection is tightened later in the NORMAL POSITION with the torque wrench.
Hand-tighten the screw (1) with the standard tool (2). In doing so, counter support at the nut (3). Standard tool: Pivoting extension 1/2 inch
Swivel extension 1/2 inch

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Position the holder (1) of the attachment rod (2) for the ride height sensor on the wishbone (3) and lock it.

Courtesy of BMW OF NORTH AMERICA, INC.