Install front brake pads (17-inch Low brake)
- Observe direction of rotation of brake pads.
The arrow (1) must always point upward in the direction of the vent valve.
- Remove the protective film of the adhesive layer (1)
at the brake pads.
The adhesive layer (1) must not be touched.
- First place the brake pads (1) completely on the hammerhead guides (2) .
- Press the brake pads (1) into the brake caliper in the arrow direction.
- Check fit of slide plate (1)
and correct if necessary.
- Remove the special tool (cable tie) 2 413 317 .
- Install the brake caliper (1) in the arrow direction.
- Replace screws.
Parts: Screws
- Tighten down screws (2) .
TIGHTENING TORQUE SPECIFICATION
| Brake caliper/brake anchor plate at front swivel bearing | ||
| M12 Replace screw. |
tightening torque | 110 Nm |
- Replace the carriage spring.
Parts: Carriage spring
The carriage spring must be replaced after each disassembly.
- Insert the carriage spring in the arrow direction (from the center of vehicle to the vehicle exterior).
The carriage spring must snap into the lock (1) .
- Check that the carriage spring (1) locks correctly in the lock.