Install the cover of the steering assembly
NOTE:
TECHNICAL INFORMATION
When the screws are tightened, the cover can twist and cause scuff marks on the anti-roll bar (risk of corrosion).
Brace the cover while the screws are being tightened. Then check the position of the cover.
When the screws are tightened, the cover can twist and cause scuff marks on the anti-roll bar (risk of corrosion).
Brace the cover while the screws are being tightened. Then check the position of the cover.
- Position the cover (1) .
- Tighten down screws (2) and (3) .
TIGHTENING TORQUE SPECIFICATION
| Cover, steering unit | ||
| screw | Tightening torque | 3 Nm |