Remove left and right output shaft

Remove output shaft 

Remove output shaft

• Release the cable for the wheel speed sensor from the holders (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the nut (1).
  NOTE: Counter-hold at the Torx socket.
• Detach the anti-roll bar link (2) from the spring strut.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Turn swivel bearing outwards.
• Set aside the anti-roll bar link (2).
• Guide out the output shaft (1) from the swivel bearing.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Secure component against falling.
• Position the aluminum drift (2) on the output shaft (1).
• Knock out the output shaft (1) from the front axle transmission with an aluminum mandrel (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the output shaft (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.