If installed: Installing the front radar sensor (FRS) with the bracket
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Hook front radar sensor (FRS) with holder (2) in the lug (3).
- Position holder (2) at the mark made during removal.
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Front radar sensor (FRS) holder/(FRSF) to support Combination oval-head machine screw tightening torque 8 Nm - Clip in vehicle wiring harness with the holder (2).
- Connect connectors (1) and lock.
Check
- Check lugs (1) on cover (2) for damage.
Result
» Tabs (2) are damaged.
Measure
- Replace cover.
- Position cover (1) and clip into the detents (2).
Adjusting the front radar sensor (FRS)
NOTE:
TECHNICAL INFORMATION
Notes on the adjustment of the ACC sensor are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: INSTRUCTIONS FOR RADAR SENSOR ADJUSTMENT DEVICE .
Notes on the adjustment of the ACC sensor are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: INSTRUCTIONS FOR RADAR SENSOR ADJUSTMENT DEVICE .
NOTE:
TECHNICAL INFORMATION
If there is a "Sensor misadjusted" fault memory entry" and a correct sensor alignment using the adjustment screw is not possible, there is a suspicion of front impact damage.
In this case, the vehicle must be carefully inspected for damage. If necessary, damaged parts must be replaced. Then adjust the ACC sensor again.
A damaged/bent holder indicates a mechanical misuse of the vehicle and will not be considered to be a warranty case.
If there is a "Sensor misadjusted" fault memory entry" and a correct sensor alignment using the adjustment screw is not possible, there is a suspicion of front impact damage.
In this case, the vehicle must be carefully inspected for damage. If necessary, damaged parts must be replaced. Then adjust the ACC sensor again.
A damaged/bent holder indicates a mechanical misuse of the vehicle and will not be considered to be a warranty case.
Checking the vehicle and components for damage
Check
- In the visible areas, precise visual inspection of:
- damage
- deformation
Result
» Damage or deformation.
Measure
- Identify damaged, deformed vehicle parts and replace.
Result
» No damage or deformation
Measure
- Adjust front radar sensor (FRS).
- Stage special tools 0 442 898 and 2 338 466 .
- Set up the special tool as per provided operating instructions.
- Connect diagnostic system.
- Service functions
- Driver assistance
- Front radar sensor (FRS)
- Commissioning the front radar sensor (FRS)
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - To adjust the front radar sensor (FRS), twist screw (1) using the standard tool.
Standard tools:
Screwdriver for hexagon socket SW3
Screwdriver for hexagon socket SW3
Screwdriver for hexagon socket SW3 (Shaft length> 90mm)