Installing the rollover protection

• With the aid of a support person, feed in the rollover protection (2) from above.
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Roll-over protection to body
  Screw Replace screw.	tightening torque	50 Nm

  NOTE: Perform the steps on the left and right side.
• Position seat belt guide bracket (2).
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the holder (3) and tighten the nuts (2).
• Position the wiring harness (1) and clip it to the brackets.
• Connect all the available plug connections and lock them.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the LTE antenna (3).
• Tighten down screw (2).
• Connect plug connection (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to INSTALLING THE TELEMATICS CONTROL MODULE .
• Refer to INSTALLING THE RADIO REMOTE CONTROL RECEIVER .
• Refer to INSTALLING THE LOWER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
• Refer to INSTALLING THE TRIM PANEL ON THE THROUGH-LOADING SYSTEM .
• Refer to INSTALLING THE COVER FOR CROSS MEMBER AT THE TOP .
• Refer to INSTALLING THE UPPER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
• Refer to INSTALLING THE REAR LEFT AND RIGHT HEAD RESTRAINT GUIDES .
• Refer to INSTALLING REAR LEFT AND RIGHT HEAD RESTRAINTS .
• Refer to INSTALLING THE REAR SEAT .
• Refer to CHECKING THE ROLL BAR .