Mount rear brake guard plate
- Install brake guard plate (2) .
- Insert screws (1) and tighten them.TIGHTENING TORQUE SPECIFICATION
Brake protection plate on the rear wheel carrier M6x12 Replace screw. tightening torque 8 Nm
Follow-up works
- Refer to INSTALLING THE REAR BRAKE DISC .
- Refer to GREASING THE BRAKE PADS, THE BRAKE ANCHOR PLATE AND THE BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .