Installing the cover on the windshield
NOTE:
Perform the steps on the left and right side.
- Note mark (A) for the cover on windshield (1) .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Move lever (1) in the arrow direction and use special tool 0 496 529 (51 3 320) to open.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Detach protective film (2) in stages from adhesive tape.
- Insert cover (1) into the guides (3) .
NOTE:
Schematic diagram is for example purposes.
Some parts may differ in certain details.
Some parts may differ in certain details.
- Place the special tool with the pressure rollers (1) up against the window edge.
- Align cover at outer edge of windshield.
- Put the cover on and visually check to make sure it is positioned correctly.
NOTE:
Schematic diagram is for example purposes.
Some parts may differ in certain details.
Some parts may differ in certain details.
- Move lever (1) in the arrow direction to close the special tool.
- Make sure the cover (3) is positioned correctly in the guide pulleys (2) .
NOTE:
Schematic diagram is for example purposes.
Some parts may differ in certain details.
Some parts may differ in certain details.
- Continue to detach protective film (1) in stages from adhesive tape.
- Use the handwheel to pull the special tool in the arrow direction over the entire upper edge of the window glass.