Installing the upper B-pillar trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Check the clips and (1) replace them as needed.
- Check guides (2)
and, if necessary, replace B-pillar trim panel (3)
.
- Attach the B-pillar trim panel (1) and guide in the safety belt.
- Guide B-pillar trim panel (1) on the top on the headliner into guides (3) .
- Clip B-pillar trim panel (1) into clips (2) .
- Check the front and rear of the B-pillar trim panel (1) for the correct fit at the edge protection.
- Feed the seat belt end fitting with the belt (1)
into the cover (2)
in the marked area carefully.
- Position the front seat belt end fitting (2) in the marked area correctly and feed it into the seat frame (3) .
- Replace the screw (1)
.
Parts: Screw
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Seat belt strap fitting to seat mechanism | ||
|---|---|---|
| Screw Replace screw. |
Tightening torque | 42 Nm |