3332 Rear Control Arms, Trailing Arms (X6 M 2020-2023)
3332 TIGHTENING TORQUE OVERVIEW
| Cover to camber control arm | ||
| Thermoplastic oval-head screw | Tightening torque | 3 Nm |
| Control arm to rear axle support | ||
| M14 Replace screw and nut. Tighten in normal position. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Control arm to wheel carrier | ||
| M16 Replace screw. Tighten in normal position. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Upper wishbone to rear axle carrier | ||
| M14 Replace eccentric bolt and nut. Tighten in normal position. |
Tightening torque | 175 Nm |
| Upper wishbone to wheel carrier | ||
| M14 Replace screw and nut. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Control link to control link bearing bracket | ||
| M12 Replace screw. Tighten in normal position. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |
| Track arm to wheel carrier | ||
| M14 Replace screw. Tighten in normal position. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Camber control arm to rear axle support | ||
| M14 Replace the eccentric screw and nut. Tighten in normal position. |
Tightening torque | 175 Nm |
| Camber control arm to wheel carrier | ||
| M14 Replace screw and nut. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Trailing arm to rear axle support | ||
| M14 Replace screw and nut. Tightening via screw. |
Snug torque | 100 Nm |
| Angle of rotation | 150° | |
| Trailing arm to wheel carrier | ||
| M14 Replace screw and nut. Tightening via screw. |
Snug torque | 100 Nm |
| Angle of rotation | 150° | |
| Special tool | ||
| Accelerating alternately by half revolutions. | tightening torque | 30 Nm |
| Control link bearing bracket to rear axle support | ||
| M14 Replace screw. |
Tightening torque | 165 Nm |
| Angle of rotation | 90° | |