Install front intake pipe
NOTE:
The steps shown on one side must be performed on both sides.
- Replace sealing rings (1) at the front and rear of the intake pipe (2).
Parts: Sealing ring
- Insert intake pipe (1) completely from top to bottom and install.
- Position intake pipe (1) correctly.
- Tighten screw (1) of the intake pipe (2).
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line to connecting piece | ||
|---|---|---|
| M8 | Tightening torque | 19 Nm |
- Feed in the intake pipe (2) under the line (3) and insert the holder (1)
- Engage holder (1).
- Place the intake pipe (2) on the air conditioning compressor (3).
- Tighten the screw (1) from the side of the wheel well on the intake pipe (2).
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line on air conditioning compressor | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to REMOVING THE INTAKE FILTER HOUSING ON THE LEFT .
- Refer to INSTALLING THE HOLDER FOR THE DME CONTROL UNIT ON THE LEFT .
- Refer to INSTALLING THE DME CONTROL UNIT OF CYLINDERS 5 TO 8 .
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .
- Refer to EVACUATING AND CHARGING CONDITIONING .