Installing the timing case cover on the cylinder head of cylinder bank 2

Replace the seal (1) .
Parts: Seal

Courtesy of BMW OF NORTH AMERICA, INC.
Position the timing case cover (2) on the cylinder head.
Tighten down screws (1) .

TIGHTENING TORQUE SPECIFICATION

Timing case cover on cylinder head
M6x20 screw	Tightening torque	9.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING COOLANT HOSE BETWEEN COOLANT RADIATOR AND ENGINE .
Refer to INSTALLING COOLANT LINE BETWEEN COOLANT PUMP AND HEAT EXCHANGER .
Refer to INSTALLING FUEL DELIVERY LINE .
Refer to SECURING COOLANT LINES FOR THE EXHAUST TURBOCHARGERS .
Refer to INSTALLING IGNITION COIL ON CYLINDER 5 .
Refer to INSTALLING THE IGNITION COIL ON CYLINDER 1 .
Refer to REMOVING THE COOLANT LINE BETWEEN THE COOLANT PUMP AND HEAT EXCHANGER PARTIALLY .
Refer to INSTALLING THE LEFT THROTTLE BODY .
Refer to INSTALLING THE CHARGE AIR COOLER ON THE LEFT AND RIGHT .
Refer to CLOSING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
Refer to CLOSING THE LOW-TEMPERATURE COOLANT CIRCUIT .
Refer to INSTALLING FRONT UNDERBODY PROTECTION .
Refer to INSTALLING THE LOWER LEFT FRONT WHEEL ARCH COVER .
Refer to INSTALLING DRIVE BELT .
Refer to INSTALLING FAN COWL .
Refer to INSTALLING THE RIGHT UNFILTERED-AIR DUCT .
Refer to INSTALLING OIL FILLER NECK .
Refer to INSTALLING BRACKET FOR RIGHT INTAKE SILENCER .
Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
Refer to INSTALLING THE FRONT-END STRUT .
Refer to INSTALLING UPPER CROSS CONNECTION .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .
Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .