Installing the auxiliary coolant pump

• Position the auxiliary coolant pump.
• Connect and lock the plug connection (2)  .
• Turn the auxiliary coolant pump downward.
• Tighten down screw (1)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Auxiliary water pump
  M6x20 screw	Tightening torque	6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the coolant lines (2)  .
• Retaining clips (1)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position holder (2)  .
• Engage the cable brackets (1)  on the holder (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Engage the tank vent valve (2)  on the holder (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE RIGHT-HAND CHARGE AIR COOLER .
• Refer to CLOSING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to CLOSING THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE LOWER LEFT FRONT WHEEL ARCH COVER .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE RIGHT UNFILTERED-AIR DUCT .
• Refer to INSTALLING OIL FILLER NECK .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .