Insert top automatic air flap control
- Connect top air flap control (3) with the appropriate connector.
- Feed out air flap control, top (3) and clip the holder (1), left and right into the ball head (2).
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Air flap control/brake ventilation duct Screw tightening torque 4 Nm
Follow-up work
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING FRONT BUMPER COVER .
- Refer to INSTALLING THE FRONT PART OF THE LEFT FRONT AND RIGHT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .