Installing rear brake pads
- Install the brake pad (1) in arrow direction.
- If necessary for brake pads with adhesive film, detach the protective film.
- Equipment version of the design clip:
- Replace the design clip (1).
Parts: Design clip
The design clip (1) must be replaced after every disassembly.
- Attach the design clip (1) and engage it in arrow direction with a screwdriver (2).
- Ensure that the retaining tab (3) is engaged correctly.
- Remove the special tool (cable tie) 2 413 317 .
- Mount brake caliper (3).
- Replace screws (1).
Parts: Screws
- Tighten the screws (1), if applicable, hold against the hexagon head (2).TIGHTENING TORQUES SPECIFICATION
Guide bolt (brake caliper on brake anchor plate) M8 tightening torque 35 Nm