Installing the trim on the front bumper cover
- Correctly position the trim (2) and engage at detents (arrows).
- Install the cover (1) and engage it at the detent.
- Connect and lock the connector on the ultrasonic sensors.
Follow-up work
- Refer to INSTALLING FOG LIGHT SUPPORT .
- Refer to INSTALLING THE TRIM ON THE CENTER ORNAMENTAL GRILLE .
- Refer to INSTALLING FRONT BUMPER COVER .
- Refer to INSTALLING THE FRONT PART OF THE LEFT FRONT AND RIGHT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE FRONT NUMBER PLATE .
- Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .