Install the cover in the engine compartment on the top right
- Guide in and correctly position the cover (3).
- Mount the expanding rivets (arrows).
- Clip the seal for hood (1) in the area of cover (3) to the clips.
- Mount the lid (2) of the washer fluid reservoir.
- Only for F95/F96 LCI vehicles:
- Guide in and correctly position cover (3).
- Clip the seal for hood (1) in the area of cover (2) to the clips.
- Mount the expanding rivets (arrows).
- Tighten down screw (4).TIGHTENING TORQUES SPECIFICATION
Cover on front-end brace M8x12 screw Tightening torque 8 Nm - Mount the lid (2) of the washer fluid reservoir.