Installing the oil-level sensor
- Clean sealing surface on oil sump.
- Position the oil-level sensor (3) .
- Tighten nuts (2)
.TIGHTENING TORQUE SPECIFICATION
Oil-level sensor Nut M6 Tightening torque 8.4 Nm - Connect plug connection (1) and lock.
Follow-up work
- Refer to REMOVING THE OIL FILLER CAP .
- Refer to FILLING ENGINE OIL .
- Refer to INSTALLING THE OIL FILLER CAP .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to INSTALLING THE STIFFENING PLATE .