Install the rear active stabilizer

• Feed in and position the active stabilizer (2).
• Replace screws (1).

  Parts  : screw

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Retainer, anti-roll bar to rear axle support
  M10 Replace screws.	tightening torque	56 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position wiring harness.
• Position the cable bracket from the top on the right retainer and the ground strap from the bottom on the right retainer.
• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Wiring harness for active stabilizer to right-hand retainer
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the cable bracket on the rear axle support.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Wiring harness for active stabilizer to right rear axle support
  M6	tightening torque	8 Nm

Follow-up work 

• Refer to SECURING THE WIRING HARNESS OF THE ACTIVE STABILIZER IN THE REAR .
• Refer to ATTACHING THE LEFT AND RIGHT ANTI-ROLL BAR LINKS TO THE ANTI-ROLL BAR .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING THE LEFT AND RIGHT REAR DIFFUSER .
• Refer to INSTALLING THE REAR LEFT AND RIGHT TENSION STRUT .
• Refer to INSTALLING THE LEFT AND RIGHT UNDERSHIELD (TANK COVER) .
• Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
• Refer to MOUNTING THE REAR RIGHT WHEEL .
• Refer to REPLACEMENT: PROGRAMMING/CODING THE ACTIVE STABILIZER .