Install front air suspension
- Position the air suspension (1) in the wheel well.
- Position cables (2) and (3) behind the air suspension (1) as viewed from the driving direction.
- Position the spring strut on the strut-tower.
- Replace screws (1).
Parts: screw
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Spring strut/air suspension strut at the front on body | ||
| M8 Replace screws. |
tightening torque | 28 Nm |
Connecting the air line on the front air suspension
- Fasten air hose to the holders (2).
- Check the banjo bolt (1) for contamination and clean, if applicable.
- Carefully screw the banjo bolt (1) into the air suspension by hand to prevent damage to the thread on the air suspension.
- Tighten the banjo bolt (1).
TIGHTENING TORQUE SPECIFICATIONS
| Air pipe to air suspension | ||
| tightening torque | 2.25 Nm | |
- Fasten cable to holder (2).
- Attach the connector (1) to the air suspension and lock it.
Follow-up work
- Refer to INSTALLING SPRING SUSPENSION STRUT .
- Refer to FASTENING THE BRAKE HOSE AND THE CABLE ON THE LEFT AND RIGHT .
- Refer to FASTENING THE WISHBONE TO THE TOP OF THE SWIVEL BEARING .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to ACTIVATING AND FILLING THE AIR SUSPENSION SYSTEM .