Install front intake pipe
- Insert intake pipe (1) completely from top to bottom and install.
- Position intake pipe (1) correctly.
- Tighten screw (1) of the intake pipe (2).TIGHTENING TORQUE SPECIFICATIONS
Refrigerant line to connecting piece M8 Tightening torque 19 Nm - Insert intake pipe (2) below the lines (3) and insert in the holder (1).
- Engage holder (1).
- Place the intake pipe (2) on the air conditioning compressor (3).
- Tighten the screw (1) from the side of the wheel well on the intake pipe (2).
TIGHTENING TORQUE SPECIFICATIONS
| Refrigerant line on air conditioning compressor | ||
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE HOLDER FOR THE DME CONTROL UNIT ON THE LEFT .
- Refer to INSTALLING THE DME CONTROL UNIT OF CYLINDERS 5 TO 8 .
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to EVACUATE AND CHARGE CONDITIONING .