Install right heat shield
- Thread in right heat shield (2) and connect with the other heat shield.
- Tighten the screw (1) at the top of heat shield (2).TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Connect the heat shield (2) with the heat shield below.
- Tighten the screw (1) at the bottom of heat shield (2).TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Tighten down screw (1).
- Position the holder of the pressure lines.
Tighten screws in areas (1).
TIGHTENING TORQUE SPECIFICATIONS
| Pressure line lug to the lateral side of the heat shield | ||
| M6x16 screw | Tightening torque | 8 Nm |
- Thread in right heat shield (2) and connect with the other heat shield.
- Tighten the screw (1) at the top of heat shield (2).TIGHTENING TORQUE SPECIFICATIONS
Heat protection plate M6x16 tightening torque 10 Nm - Connect the heat shield (2) with the heat shield below.
- Tighten the screw (1) at the bottom of heat shield (2).
TIGHTENING TORQUE SPECIFICATIONS
| Heat protection plate | ||
| M6x16 | tightening torque | 10 Nm |