Fastening the wiring harness section to the left cylinder head cover

NOTE: RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.

NOTE: RISK OF DAMAGE
Malfunction or failure of the DME.
Grounding points that are not screwed on may lead to malfunction or failure of the DME.

Screw all screw points of the cable ducts on again. Some of the screw points are also grounding points.

Check the cover (1) for damage.
Replace the faulty or fuel-soaked cover.
Insert and install the cover (1) at the left cylinder head cover.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the wiring harness section (4) and install.

Tighten down screw (3).

TIGHTENING TORQUE SPECIFICATIONS

Cable duct to cylinder head cover/cylinder head
M6 screw	tightening torque	10 Nm

Position the grounding cables and tighten the nuts (2).

TIGHTENING TORQUE SPECIFICATIONS

Ground cable on cylinder head cover/ground pin
Nut M5	tightening torque	4.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
The connectors (1) must engage audibly.

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
Check all connectors (1) on the injectors again to ensure they are correctly fitted.
Check if all connectors (1) have been engaged.

Courtesy of BMW OF NORTH AMERICA, INC.
Pull the coolant hose (1) in the marked area carefully upwards over the refrigerant line and lay it down.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Cable duct to cylinder head cover/cylinder head
M6 screw	tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully press the coolant hose (1) down in the marked area and position at the refrigerant line (3).
Lock holder (1).
The holders (1) must snap-in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the wiring harness section (4) and install.
Secure the cable (3) in the clamps.

Tighten down screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Cable duct to cylinder head cover/cylinder head
M6 screw	tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
The connectors (1) must engage audibly.
Secure the clamps (arrows).
Connect the connector (2) from the oxygen sensor monitor with the holder (3) and lock.
The connector (2) must engage audibly.
Connect connectors (1) and lock.
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the wiring harness section (2) and install.
Secure the clamps (arrows).
Position the ground cable and tighten the screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Ground cable to cylinder head cover/cylinder head
M6	tightening torque	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.