Installing the tension strut at the right rear and if necessary, on the left side

Installing the right rear tension strut 

Installing the rear tension strut 

• Install the tension strut (3).
• Tighten the screws (1) and the nut (2).

Torsion strut on body and holder
M12x25 Replace screws.	Joining torque  Angle of rotation	100 Nm 90°
Nut M10	Tightening torque	38 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the undershield (tank cover) at right 

Installing undershield (tank cover) 

• Insert the undershield (1).
• Tighten all bolts and nuts (arrows).

Undershield, side
Hexagon screw	Tightening torque	2.6 Nm
Plastic nut	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

For dual-flow exhaust system: 

Installing the rear left tension strut 

Installing the rear tension strut 

• Install the tension strut (3).
• Tighten the screws (1) and the nut (2).

Torsion strut on body and holder
M12x25 Replace screws.	Joining torque  Angle of rotation	100 Nm 90°
Nut M10	Tightening torque	38 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Installing undershield (tank cover) 

• Insert the undershield (1).
• Tighten all bolts and nuts (arrows).

Undershield, side
Hexagon screw	Tightening torque	2.6 Nm
Plastic nut	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.