Installing the engine on the assembly jig
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
- Get the set of special tools 0 495 187 (00 2 300) ready.
| Number | Description |
|---|---|
| 1 | Assembly jig |
| 2 | Flange |
| 3 | Crank |
| 4 | cover panel |
| 5 | shelf |
| 6 | Rear shaped part |
| 7 | Collection pan |
| 8 | Front shaped part |
| 9 | Front wheel |
| 10 | Rear wheel with stop |
| 11 | Mat |
- Have the special tool 2 411 718 ready.
- Position the assembly jig 0 495 187 (00 2 300)
with the special tool 0 495 196 (00 2 320)
.
- Tighten the screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Special tool 00 2 320 to special tool 00 2 300 | ||
| M14X95 | Tightening torque | 130 Nm |
- Screw the special tool 2 413 082 to the 0 495 196 (00 2 320) special tool.
- Tighten the screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| special tool 2 413 082 to special tool 00 2 320 | ||
| M12x65 | Tightening torque | 100 Nm |
- Position and secure the special tool (motor mount) 2 411 718 on the engine.
- Tighten the screws (marks).
TIGHTENING TORQUE SPECIFICATIONS
| special tool 2 411 718 to crankcase | ||
| M10x30 | Tightening torque | 38 Nm |
- Slowly lower the engine.
- Ensure that special tool 2 411 718 engages in special tool 2 413 082 .
- Hand-tighten nuts (1).
The clamping jaws must make full contact.
- Release both hooks of the special tool (lifting equipment) 0 490 567 (11 0 020) at the front and rear of the engine from the mounting brackets.
- Remove the workshop crane 2 220 718 .