Install luggage compartment floor covering

• Install the luggage compartment floor covering (1), engage at the rear at the detents (3) and lock at the handle (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the luggage compartment floor covering (electrical roller cover for luggage compartment) 

Prerequisite 

The electrical roller cover for luggage compartment must be up. Run it up If applicable.

• Feed in the luggage compartment floor covering (2) and correctly position and lock on handle (3).
• Tighten the screws and close the covers (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Luggage compartment floor covering on holder
  Oval-head screw	Tightening torque	15 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fold up the lid (1) and connect the connector (2) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lift the luggage compartment floor covering.
  NOTE: Perform the steps on the right and left side.
• Slide the clamp (1) back from the removal position (2) again.
• Insert the gas pressure spring (3) onto the ball head and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the luggage compartment floor covering (with 3rd row of seats) 

• Correctly position the luggage compartment floor covering (2) and lock on handle (3).
• Tighten the screws and close the covers (1).

Courtesy of BMW OF NORTH AMERICA, INC.