Removing the eccentric shaft (cylinder head removed)

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .

Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove all screws (marks).
Guide out and remove bearing brackets (1) to (6) (arrows).
Set down bearing brackets (1) bis (6) neatly in special tool 0 495 105 (11 4 480) .
Feed out and remove bearing cap (A) .
Place bearing cap (A) neatly in special tool 0 495 105 (11 4 480) .
Feed the air eccentric shaft (1) out toward the top and remove.

Courtesy of BMW OF NORTH AMERICA, INC.