Removing the sliding block of cylinder bank 1
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Position the special tool 2 249 166
on the intake camshaft (1)
in the area of the sliding block (2)
to be disassembled.
- Preload the sliding block (3) with the special tool 2 249 166 (2) in direction of arrow .
- Loosen screw (1) .
- Remove the gate (3) and place it arranged in order into 0 495105 (11 4 480).
- Repeat the step for all the gates.