Observing the hardening time of the screw locking agent on the screw plug

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
A hardening time of 24 h must be observed after wetting the screw with the screw locking agent.
During the hardening time, the engine must not be started.
Filling the coolant circuit is only permitted after the hardening time.

Observe the hardening time.
The high-temperature coolant circuit is not allowed to be filled during the hardening time.
Observe the hardening time.
It is not allowed to start the engine during the hardening time.

Courtesy of BMW OF NORTH AMERICA, INC.