Installing the throttle body

• Replace the sealing ring (1) with the special tool 0 496 714 (00 9 030) .

  Parts  : Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position throttle body (2).
• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

• Install the throttle body (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Throttle body to intake plenum
  6X50	Tightening torque	7 Nm

• Replace the screw (1). Parts  : screw
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Holder for coolant hose to throttle body
  M6x16 screw Replace screw.	Tightening torque	11.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE CHARGE AIR LINE .
• Refer to INSTALLING THE ENGINE CONTROL UNIT COVER .
• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING ACOUSTIC COVER .