Replacing the cylinder head (remounting components)
- Release the venting connector (1) at the cylinder head (3).
- Release the coolant temperature sensor (2) at the cylinder head (3).
- Replace the cylinder head (3).
Parts: Cylinder head
- Tighten venting connector (1) on cylinder head (3).TIGHTENING TORQUE SPECIFICATIONS
Venting connector/special tool to cylinder head M10 Tightening torque 18 Nm - Tighten the coolant temperature sensor (2) on the cylinder head (3).
TIGHTENING TORQUE SPECIFICATIONS
| Coolant temperature sensor at cylinder head | ||
| Sensor | Tightening torque | 18 Nm |