Replace intake plenum
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
- Loosen clamp (1).
- Loosen screw (2).
- Remove the boost pressure sensor (3).
- Feed out the rubber grommet (1) and remove it.
- Loosen clamp (2).
- Loosen clamp (1).
- Remove the screws (arrowed).
- Remove the throttle bodies (1).
- Replace the sealing ring (1) with the special tool 0 496 714 (00 9 030)
.
Parts: Sealing ring
- Feed in and install the throttle body (1).
- Tighten the screws (arrowed).
TIGHTENING TORQUE SPECIFICATIONS
| Throttle body to intake plenum | |
|---|---|
| M6x50 | Tightening torque 7 Nm |
- Check the sealing ring (1) for damage, replace it if necessary.
Parts: Sealing ring
- Apply a thin coat of lubricant to the sealing ring (1) of the boost pressure sensor.
- Insert and install the boost pressure sensor (3).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Boost pressure sensor to intake plenum | |
|---|---|
| TS6x20 | Tightening torque 5 Nm |