When replacing intake camshaft: Remount camshaft sensor wheel

• Rotate intake camshaft, if necessary in the position shown up to the recess (2).
• Loosen screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide out and remove the camshaft sensor wheel (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the camshaft sensor wheel (1) into the new intake camshaft.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Rotate intake camshaft, if necessary in the position shown.

NOTE: The recess (2) must point up.

• Position camshaft sensor wheel and tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Camshaft sensor wheel to intake camshaft
M4x35	Tightening torque  4.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.