Install heat management module

NOTE: TECHNICAL INFORMATION
Improper routing of cables and wiring harnesses .
Trapped, crushed or damaged cables may cause short circuits and malfunctions .

Route all cables without abrasions, do not trap and crush.

NOTE: TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents.

NOTE: TECHNICAL INFORMATION
Damage to the surface .
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage .

Do not use any metal-cutting tools.

Clean sealing surfaces (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the sealing rings (1) on connecting pipe (2).
Parts: Sealing ring
Coat sealing rings (1) with coolant before installing.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the sealing rings (1) on heat management module (2).
Parts: Sealing ring
Coat the sealing rings (1) on the heat management module (2) with coolant before installing.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install the connecting pipe (1) in the arrow direction on the heat management module (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the heat management module (1) with the connecting pipe (2).
Make sure that the connecting pipe (2) is installed correctly.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Heat exchange module to crankcase
M6	Tightening torque 9 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Secure the clamp (3).
Feed in and install coolant line (2).
Make sure that the coolant line (2) engages audibly.
Connect and lock the connector (1).
Make sure the connector (1) engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect and lock the connector (1).
Make sure the connector (1) engages audibly.
Connect and lock coolant lines (2) and (3).
Ensure that coolant lines (2) and (3) snap in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install the support (4) for the intake plenum.
Tighten the screws (3).

TIGHTENING TORQUE SPECIFICATIONS

Support to cylinder head
M6x16	tightening torque 8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Secure clamps (2).
Fasten the coolant line (1) on the support (4) for the intake plenum.

Follow-up work

Refer to INSTALL INTAKE PLENUM .
Refer to INSTALLING THE TANK VENT VALVE .
Refer to INSTALLING THE LOW-TEMPERATURE COOLANT EXPANSION TANK .
Refer to INSTALLING INTAKE FILTER HOUSING .
Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .
Refer to CONNECTING ALL BATTERY GROUND LEADS .
Refer to CHECKING COOLING SYSTEM FOR WATERTIGHTNESS .
Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to INSTALLING FRONT UNDERBODY PROTECTION .
Refer to INSTALLING ACOUSTIC COVER AT REAR .
Refer to INSTALLING ACOUSTIC COVER .
Refer to TAKING HOOD OUT OF THE SERVICE POSITION .