Removing power distribution for front positive battery cable

Preliminary work 

• Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to REMOVING LEFT AND RIGHT WIPER ARM .
• Refer to REMOVING THE COWL COVER .
• Refer to REMOVING RIGHT SUSPENSION STRUT BRACE .

• Loosen screws (1).
• Remove the right cowl upper part (2).
• Loosen screws (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1).
• Loosen screws (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Remove the center cowl upper part (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Guide out sealing frame (2) upwards.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unclip the cover (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Undo the nuts (1) and feed out the corresponding cables.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unclip the cover (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Undo the nuts (1) and feed out the corresponding cables.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Feed out the power distribution box (2) slightly in an upwards direction.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock and disconnect plug connections (1).
• Remove the power distribution (2).

Courtesy of BMW OF NORTH AMERICA, INC.