Install rear brake pads
- Install the brake pads (1) in the direction of the arrow.
- If necessary, detach the protective film from the brake pads with an adhesive film.
- Equipment version of the design clip:
- Replace the design clip (1).
Parts : Design clip
The design clip (1) must be replaced after every disassembly.
- Apply the design clip (1) and snap into place with a screwdriver (2) in the direction of the arrow.
- Ensure that the retaining tab (3) is correctly engaged.
- Remove the special tool (cable tie) 2 413 317 .
- Mount brake caliper (3).
- Replace screws (1).
Parts : Screws
- Tighten the screws (1), if applicable, hold against the hexagon head (2).
TIGHTENING TORQUE SPECIFICATIONS
| Guide bolt (brake caliper on brake anchor plate) | ||
|---|---|---|
| M8 | tightening torque | 35 Nm |