Preparing New Part

Further information is available.

• Adjust new parts with an alignment bracket or a universal fixture and secure.
• Prepare area (1) for structural adhesive bonding of aluminum to aluminum.
  NOTE: TECHNICAL INFORMATION 
  For additional information see: 41 00...Transferring hole pattern.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Transfer the hole pattern of the engine mount (2) to the new part in area (1). Drill out holes to dia. 6.8 mm.
• Prepare area (1) for structural adhesive bonding of aluminum to aluminum.
• In area (1), transfer the positions of the holes from the spring support to the new part. Drill out holes to dia. 6.8 mm.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Prepare areas (1) and (2) for structural adhesive bonding of aluminum on aluminum.
• In areas (1) and (2), transfer the positions of the holes from the spring support to the new part. Drill out holes to dia. 6.8 mm.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the bonded rivet connection in area (1).
• Remove the unneeded component (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fit in new part.
• Prepare areas (1) for structural adhesive bonding of aluminum to aluminum.
• Prepare area (2) for structural adhesive bonding of steel to aluminum.
• In areas (1) and (2), transfer the positions of the holes to the new part. Drill out holes to dia. 6.8 mm.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Prepare areas (1) for structural adhesive bonding (with punch rivets) of aluminum to aluminum.
• Remove the new parts and deburr the bores.

  Courtesy of BMW OF NORTH AMERICA, INC.