Remove the tail light on the right side panel
Preliminary work
- Refer to REMOVING THE ROLLER COVER FOR LUGGAGE COMPARTMENT .
- Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to REMOVING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to REMOVING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to REMOVING RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING THE REAR DOOR SILL COVER STRIP (ON ELECTRICAL REAR SEAT) .
- Refer to REMOVING THE BOTTOM LEFT C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to REMOVING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Unclip the cover of the water channel (1) in arrow direction.
- Unfold sound insulation (1) and loosen the nut below.
- Protect the body in the area of the tail light with adhesive tape.
- Loosen screws (1) of the tail light (2).NOTE: TECHNICAL INFORMATION
Observe the note on unlocking and disconnecting plug connections.
For additional information see: UNLOCKING AND DISCONNECTING DIFFERENT PLUG CONNECTIONS . - Unlock the connector (1) on the tail light (2) and disconnect.