Installing the sliding block of cylinder bank 2

• Remove the oil and dirt from the sliding block (3)  .
• Position the sliding block (3)  and abut with the screw (1)  .
• Position the special tool 2 249 166  on the intake camshaft (1)  in the sliding block (2)  area.
• Preload the sliding block (3) with the special tool 2 249 166 (2) in direction of arrow. 
• Tighten down screw (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Sliding block on cylinder head
  Screw M7x35 10.9	Tightening torque	20.5 Nm

• Relieve the special tool 2 249 166 (1)  and feed it out of the camshaft (2)  and place aside.
• Repeat the step for all the gates.

Courtesy of BMW OF NORTH AMERICA, INC.