LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2022 >> X5 M Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Turbocharger, Intake Plenum, Oxygen Sensors, Water Pump, Thermostat, Coolant Lines, And Engine Vacuum Pump -- Repair X5 M (F95) >> 11 65 Turbocharger With Control >> 11 65 185 Removing and installing/replacing lower heat shield (X5 M) >> Removing heat shield at bottom

Removing heat shield at bottom

WARNING: Hot exhaust system. 
Risk of burning! 
  • Any work must exclusively be carried out with an exhaust system that has cooled down.
WARNING: Hot surfaces. 
Risk of burning! 
  • Perform all work only on components that have cooled down.
WARNING: Hot fluids. 
Risk of scalding! 
  • Conduct all work in the vehicle wearing appropriate personal protective equipment only.
NOTE: TECHNICAL INFORMATION 
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
NOTE: TECHNICAL INFORMATION 
Grease the threads of new oxygen sensors thinly and evenly.
For oxygen sensors that are reused, the following should be observed:
Thinly and evenly grease the oxygen sensor on the thread only. Do not clean the part of the oxygen sensor that does not protrude into the exhaust line (sensor ceramics) and do not grease.
For additional information see: 11 00... OVERVIEW OF CONSUMABLES IN APPLICABLE BMW PARTS CATALOGUE .

Preliminary work 

G15070015Courtesy of BMW OF NORTH AMERICA, INC.