Removing VANOS solenoid actuator, exhaust of cylinder bank 1
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
- Protect working area.
- Handle tools and components carefully.
Preliminary work
- Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE FRONT-END STRUT .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING THE INTAKE FILTER HOUSING ON THE LEFT .
- Refer to REMOVING THE LEFT UNFILTERED-AIR DUCT .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING OIL FILLER NECK .
- Refer to REMOVING THE RIGHT UNFILTERED-AIR DUCT .
- Refer to REMOVING THE FAN COWL .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE WHEEL ARCH COVER AT THE BOTTOM FRONT LEFT AND BOTTOM RIGHT .
- Refer to DRAINING THE COOLANT FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to REMOVING RIGHT CHARGE AIR COOLER .
- Unlock plug connection (1)
and disconnect.
- Turn VANOS solenoid actuator (1) about 50° counter-clockwise with the special tool 2 360 895 (2) .
- Remove VANOS solenoid actuator (1) .