Installing the catalytic converter near engine, bottom at bank 1
WARNING:
Hot exhaust system.
Risk of burning!
Risk of burning!
- Any work must exclusively be carried out with an exhaust system that has cooled down.
- Replace gasket (1).
Parts: Seal
- Position the catalytic converter (2) at the bottom.
- Replace nuts (1).
Parts: Nuts
- Tighten nuts (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bulkhead catalytic converter to catalytic converter near engine | ||
|---|---|---|
| Nut M8 Replace nuts. |
Initial torque | 17 Nm |
| Tightening torque | 28 Nm | |
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING TOP HEAT SHIELD .
- Refer to CONNECTING THE EXHAUST SYSTEM .
- Refer to INSTALLING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 5 TO 8 .
- Refer to INSTALLING THE CROSSING OF THE TRANSMISSION WIRING HARNESS .
- Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE .
- Refer to INSTALLING BRACKET FOR RIGHT INTAKE SILENCER .
- Refer to INSTALLING OIL FILLER NECK .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR FOR CYLINDERS 1 TO 4 .
- Refer to FASTENING THE ENGINE VENTILATION LINE OF CYLINDER BANK 1 .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR FOR CYLINDERS 5 TO 8 .
- Refer to FASTENING THE ACTIVATED-CHARCOAL FILTER LINE .
- Refer to FASTENING THE ENGINE VENTILATION LINE OF CYLINDER BANK 2 .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .