Installing the hydraulic unit

• Position hydraulic unit (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace nuts.

  Parts:  Nuts

• Install the nuts (1) and tighten.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Hydraulic unit to pedal bracket
  M8 Replace nuts. 1x retightening at hydraulic unit after 10 min.	tightening torque	22 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock brake pedal (1) in place in the arrow direction with the brake booster.
• Ensure that the brake pedal is completely locked with the brake booster! 

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Do not interchange brake lines. Mark the brake lines before disassembly (for example, VL/VR/HR/HL). 
  Do not bend brake lines.
  Close off connecting bores with seal plugs.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fit brake lines (1) and tighten.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Brake pipe screw connection/Union screws
  	tightening torque	17 Nm

• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1).
• Install the cable clip (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH THE REAR BRAKE AND AIR BLEED (AFTER PART EXCHANGE) .
• Refer to FLUSHING AND BLEEDING FRONT BRAKES (AFTER PART EXCHANGE) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER PART EXCHANGE) .
• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .
• Refer to FUNCTIONAL CHECK OF INTEGRATED BRAKE SYSTEM .
• Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .