Install rear brake discs
NOTE:
TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
- Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
- Mount brake disk (2).
- Replace screws.
Parts: Screws
- Insert screws (1) and tighten.TIGHTENING TORQUE SPECIFICATIONS
Brake disc to rear wheel hub M8
Replace screw.tightening torque 16 Nm - Mount brake anchor plate.
- Replace screws (1).
- Parts:
Screws
Insert screws (1) and tighten.
TIGHTENING TORQUE SPECIFICATIONSBrake anchor plate to rear wheel carrier M12
Replace screw.Tightening torque 130 Nm
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .