Installing rear brake pads

Install the brake pad (1) in arrow direction.
If necessary for brake pads with adhesive film, detach the protective film.

Courtesy of BMW OF NORTH AMERICA, INC.
Equipment version of the design clip:
Replace the design clip (1).
Parts: Design clip

The design clip (1) must be replaced after every disassembly.
Attach the design clip (1) and engage it in arrow direction with a screwdriver (2).
Ensure that the retaining tab (3) is engaged correctly.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the special tool (cable tie) 2 413 317.
Mount brake caliper (3).
Replace screws (1).
Parts: Screws

Tighten the screws (1), if applicable, hold against the hexagon head (2).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Guide bolt (brake caliper on brake anchor plate)
M8	tightening torque	35 Nm