Install the knock sensors on the right

Precondition

Ignition is switched off.

The vehicle battery is disconnected.

NOTE: TECHNICAL INFORMATION
When installing the knock sensors, the tightening torque must be observed.
Non-compliance with the tightening torque can lead to malfunction.

Clean the contact surfaces of the knock sensors at the cylinder head.
Position the knock sensors and secure them with bolts (3).
Tighten down screws (3).

TIGHTENING TORQUE SPECIFICATIONS

Knock sensor to crankcase
M8x30	tightening torque	21.4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (2) and lock.
The connectors (2) must engage audibly.
Mount the clamp (1) on the intake plenum.
Connect positive battery cable to the starter motor.
Secure positive battery cable at the clamp (2).
Tighten nut (1).

TIGHTENING TORQUE SPECIFICATIONS

Battery positive lead to starter
M8	tightening torque	13.4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector (1) to the starter and lock.
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to RECONNECTING ALL BATTERY GROUND LEADS .