Remove expansion tank

NOTE: TECHNICAL INFORMATION
Before first working on the DSCi brake (integrated brake), the "DSCi" web-based training must be passed successfully.
The "DSCi" web-based training is started in the Learning Management System (TMSi).

NOTE: TECHNICAL INFORMATION
Before removing the hydraulic unit, the vehicle battery must be disconnected without fail!
The vehicle battery must never be connected during a repair!
Otherwise a brake bleeding procedure must be carried out after the repair.
For additional information: see VENT BRAKING SYSTEM (DURING PART EXCHANGE) .
The vehicle battery may only be reconnected when the brake system is completely filled with brake fluid and vented!

NOTE: TECHNICAL INFORMATION
Use only BMW-approved brake fluids.
For additional information see: "Fluid Capacities" tab for the selected vehicle.

Preliminary work

Refer to DEACTIVATING VEHICLE ELECTRICAL SYSTEM .
Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
Refer to REMOVING LEFT AND RIGHT WIPER ARM .
Refer to REMOVING WINDSHIELD PANEL COVER .
Refer to REMOVING TRAILING LINK AT SPRING BOLT .
Refer to REMOVING WIPER CONSOLE .

Unfasten plug connections (1) .
Remove the cable clip (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Disconnect plug connection (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Unscrew the screw (1) on the rear of the expansion tank.

Courtesy of BMW OF NORTH AMERICA, INC.
Extract brake fluid out of the expansion tank as far as possible.
Catch escaping brake fluid.
Unscrew the screws (1) and remove the expansion tank (2) upward.

Courtesy of BMW OF NORTH AMERICA, INC.