Removing Engine Mount In Front Of Bulkhead With Wheel Arch

NOTE: TECHNICAL INFORMATION 
For additional information see: 41 00...
Releasing bonded connections

• Release bonded rivet connections in the areas (1)  and (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the spot-welded adhesive joints in area (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  For additional information see: Open riveted joints (41 00).
• Release bonded rivet connections in the areas (1)  and (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release bonded rivet connections in the areas (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Mark severance cut (1)  according to schematic diagram and disconnect.
• Remove engine mount and wheel arch (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Open welded connections in area (1)  .
• Unscrew the self-tapping screws and bonded connection in area (2)  .
• Remove reinforcement (3)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• (1)  Mark severance cut () as pictured and cut. Detach the engine mount in sections.
• Unscrew the self-tapping screw and bonded connection in the area (2)  .
• Loosen the bonded rivet connections in the areas (3)  partially with the belt sander.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unscrew the self-tapping screws and bonded connections in the areas (1)  . Remove the engine mount (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.